Installing the Outer CV Joint

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Dished Washer And Thrust Washer On Outer Joint

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Plate Spring
Thrust Ring

-- Install the new circlips.

-- Slide new CV boot onto drive axle if necessary.

-- Use a plastic hammer to install it on the shaft until the locking ring locks secure.

Fig 2: Driving Off Cover For Inner Joint

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove securing ring.

-- Remove both clamps, and push joint boot toward outer joint.

-- Drive off protective boot with drift.

Fig 3: Identifying Tools To Press Off Inner Constant Velocity Joint

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.