Power Steering Pump Overview

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Vane pump is not designed to be serviced. If there are customer complaints, the cause must be determined using a pressure and leak test. If there is a malfunction, replace the vane pump.

NOTE:

Always replace seals.

Do not reuse fluid you have drained.

If power steering fluid is low in the reservoir, check the steering system for leaks.

If there are leaks in the area of the line connections, the lines/connections must first be inspected for leaks, tightened as necessary and wiped dry.

Replacement power steering pumps from the distribution center do not contain any fluid. Before installing, fill pump with hydraulic oil G 004 000 M2 and turn pump by hand. Otherwise, the power steering pump may be noisy when operating or may even be damaged.

Type of power steering fluid: Hydraulic Fluid G 004 000 M2.

Fig 1: Identifying Power Steering Pump And Component Parts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bracket
Pressure Line
- 32 Nm
Seal
- Always replace if removed.
Intake Hose
- Pay attention to the installed position of the power steering pump: the marking on the intake hose must line up with the marking on the power steering pump.
Spring Clamp
- Install on the marking on the intake hose.
Power Steering Pump
- Allocation.
- Removing and Installing. Refer to VANE PUMP .
- Delivery Pressure, Checking. Refer to POWER STEERING PUMP DELIVERY PRESSURE, CHECKING .
- Fill with oil prior to installation.
Belt Pulley
Bolt
- 22 Nm
Bolt
- 22 Nm
- Quantity: 3