Fastener Tightening Specifications
WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
| Component |
Fastener Size |
Nm |
| Accessory bracket to cylinder block bolt |
- |
25 |
| Air conditioning compressor to accessory bracket bolt/stud bolt |
- |
25 |
| Air conditioning compressor ribbed belt, belt tensioner to accessory bracket bolt |
- |
35 |
| Connecting rod bearing cap to connecting rod bolt |
- |
30 + 90° |
| Control housing cover to cylinder block bolt |
- |
25 |
| Crankshaft bearing cap to cylinder block bolt |
- |
40 + 90° |
| Drive plate/flywheel to crankshaft bolt |
- |
60 + 90° |
| Engine mount to accessory bracket bolt |
- |
40 + 90° |
| Engine speed sensor to control housing cover bolt |
- |
5 |
| Generator to accessory bracket bolt |
- |
25 |
| Generator, power steering pump and coolant pump ribbed belt, belt tensioner to accessory bracket bolt |
- |
35 |
| Idler pulley with bracket to accessory bracket bolt |
- |
25 |
| Lower relay pulley bracket bolt |
- |
25 |
| Plug to cylinder block |
- |
30 |
| Power steering pump to accessory bracket bolt |
- |
23 |
| Power steering pump pulley to power steering pump bolt |
- |
23 |
| Pressure relief valve |
- |
27 |
| Sealing flange to cylinder block bolt |
- |
10 |
| Vibration damper to crankshaft bolt 1, 2 |
- |
50 + 90° |