Vibration Damper: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Replace bolts
Use strength category 10.9 only
50 Nm + 90° turn

After Disassembly and Assembly Work:

-- Remove the Locking Pin T40069 and install the sealing plug -1- on cylinder block in the rear.

Fig 1: Identifying Crankshaft Must Not Be Rotated Out Over TDC Marking

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The rest of the installation follows the reverse of the removal procedures.