Drive Plate: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Depth Gauge
| Work Steps | Specified Value Measurement | Tightening Specification | Additional Turn |
|---|---|---|---|
| 1. Replace bolts | - | - | - |
| 2. Tightening the bolts | - | 30 Nm | - |
| 3. Measuring. Refer to DRIVE PLATE . | 18.8 to 20.4 mm | - | - |
| 4. Tightening the bolts | - | 60 Nm | - |
| 5. Tightening the bolts with additional turn | - | - | 90° further (tightening can be done in steps). |
| 6. Installing the sealing plug | - | 30 Nm | - |