Auxiliary Components Bracket: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE: Note the different bolt lengths.

-- Mount the subassembly bracket and then install the bolts -5-.

-- Tighten the new bolt in three steps in the following sequence: -1 through 6-

-- Tighten bolts by hand.

-- Tighten the bolts to 20 Nm.

-- Tighten the bolts an additional 90°.

-- Install the engine mount. Refer to ENGINE MOUNT .

-- Install the generator. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] Removal and Installation .

-- Install the A/C compressor to the auxiliary components bracket. Refer to Removal and Installation .

-- Install the ribbed belt tensioning damper (generator, power steering pump and coolant pump). Refer to Installing

-- Install the ribbed belt tensioner (A/C compressor). Refer to Installing

-- Attach the power steering pump to the auxiliary components bracket. Refer to Removal and Installation .

CAUTION:

Risk of damaging due to reversed running direction on a used ribbed belt:

Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

-- Install ribbed belt. Refer to Installing Ribbed Belt

Fig 1: Ribbed Belt Routing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Power steering pump
Ribbed belt for generator, vane pump and coolant pump
Belt pulley - generator
Idler roller
Belt pulley - air conditioning compressor
Ribbed belt for A/C compressor
Belt pulley - crankshaft
Tension roller for A/C compressor ribbed belt
Tensioning roller for ribbed belt for generator, vane pump and coolant pump
Belt pulley - coolant pump

NOTE:

Remove the Adapter 10 - 222 A /7 from the cylinder block -illustration-.

Fig 2: Adapter 10 - 222 A /7 Engaged On Engine Block

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.