Test Sequence

WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not interchange used bearings

Bearing shells that are worn down to the nickel layer must be replaced.

-- Remove main bearing cap and clean bearing cap and pins.

-- Place Plastigage® over entire width of bearing journal or into bearing shells.

Plastigage® must rest in center of bearing shell.

-- Install and tighten the main bearing cover. Do not turn the crankshaft while doing this.

-- Remove the main bearing cover again.

-- Compare width of Plastigage® with measuring scale.

Radial clearance:

New: 0.023 to 0.043 mm
Wear limit: 0.07 mm