Coolant Pump: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Pay attention to the installed position of the coolant pump. The plug inside the housing faces downward.
Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .
Install the battery tray. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] Removal and Installation .
Install the battery. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] Removal and Installation .

NOTE: Remove the Adapter 10 - 222 A /7 from the cylinder block -graphic below-.

Fig 1: Identifying Adapter 10 - 222 A /7 Engaged On Engine Block

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.