Coolant Hose Connection Diagram
WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Radiator
- Removing and installing, refer to RADIATOR .
- Replace the coolant after replacing the heater core.
- Coolant Pipe
- Intake Manifold
- Coolant Pump and Coolant Thermostat
- Coolant pump, removing and installing, refer to COOLANT PUMP .
- Coolant thermostat, removing and installing, refer to COOLANT THERMOSTAT .
- Checking coolant regulator. Refer to -item 17-.
- Front Coolant Pipe
- Secured to bracket for assemblies
- Reservoir
- With cap
- Pressure relief valve inside cap, checking. Refer to COOLING SYSTEM, CHECKING FOR LEAKS .
- Rear Coolant Pipe
- Cylinder Head/Cylinder Block
- Replace the coolant after replacing the heater core.
- Coolant Distribution Housing
- Heater Core
- Replace the coolant after replacing the heater core.
- Transmission Fluid Cooler
- Only for vehicles with an automatic transmission
- Bypass Thermostat
- Only for vehicles with an automatic transmission
- Assembly overview, refer to Figure.
- Checking Bypass Thermostat .
- Oil Cooler
- Coolant Hose
There are two versions:
- Without an engine preheater
- With an engine preheater
- Preheater
- Only on vehicles with an engine preheater
- Throttle Valve Control Module -J338-
- The throttle valve control module heated by the coolant has been discontinued.
- Lower Radiator Connection
- Upper Radiator Connection