Front Bumper Cover: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connectors from any electrical components.

-- With the assistance of a second technician, guide the front bumper cover -1- parallel onto the guide on the lock carrier.

-- Push the front bumper cover -1- into the guides on the left and right fenders until it locks.

-- Install the front bumper cover -1- in the striker pin in the mount next to the left and right headlamp.

-- Pay attention to the parallel alignment and the gap dimensions

-- Attach and tighten bolts -2-, -3- and -4-.

-- Install the front trim, refer to RADIATOR GRILLE/FRONT TRIM .