Front License Plate Holder, Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The license plate holder is not installed on all models for all markets.

The license plate holder can have different sizes depending on the market.

The contour of the bumper determines the height of the license plate holder.

Drill 12 mm holes.

Fig 1: Identifying Emblem, Front Bumper Cover, License Plate Holder And Clips

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

With Holes Present

-- Position the license plate holder -3- on the front bumper cover -2- and push the clips -4- in.

With No Holes Present

-- Center the license plate holder -3- on the front bumper cover -2- with the emblem -1-.

-- Make a 12 mm stop depth mark and drill the holes.

-- Position the license plate holder -3- on the front bumper cover -2- and push the clips -4- in.