LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Bumpers (Hatchback)) >> 63 Bumpers >> Description And Operation >> Front Bumper >> Front Bumper Carrier Overview >> Notes

Front Bumper Carrier Overview: Notes

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Bumper Carrier Components Overview
GWWM63-10036Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Front Bumper Carrier
    • Note the installed dimension, refer toFig 2
  2. Bolt
    • 8 Nm
    • 2 on each side
    • Note the installed dimension, refer to Fig 2
  3. Bolt
    • 60 Nm
    • 4 on each side
  4. Bolt
    • 1 on each side
    • Convertible only
  5. Noise Insulation Bracket
    • Convertible only
  6. Nut
    • 20 Nm
    • 1 on each side
    • Convertible only
  7. Foam piece
    • Self-adhesive
    • For USA and Canada and Rest of World
  8. Foam piece
    • Self-adhesive
    • Only for Rest of World
  9. Foam piece
    • Self-adhesive
    • Only for USA and Canada
Fig 2: Installed Dimension For Front Bumper Carrier On Lock Carrier
GWWM63-10030Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
WARNING: Follow the following steps when installing the front bumper carrier -1- on the lock carrier -2-.

Dimension -a- = 1 mm

Dimension -b- = 10 mm

scientia non olet · About LEMON Manuals