LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (2.0L - Exhaust System & Emission Controls - Engine Code(S): CBFA & CCTA (Hatchback)) >> 26 Exhaust System, Emission Controls >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2013 Volkswagen Beetle and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Clamping Sleeve Nut
-- Individual Clamp - 25
-- Continuous Clamp - 35
Cross Member to Underbody Nut - 20
Front Exhaust Pipe with Catalytic Converter to Exhaust Manifold/Turbocharger Nut 1, 3 - 40
Oxygen Sensor - 55
Secondary Air Injection Pump Motor Bracket to Underbody Nut (2) - 25
Secondary Air Injection Pump Motor to Bracket Nut (2) - 9
Secondary Air Injection Solenoid Valve Bolt (2) - 9
Suspended Mount to Subframe Bolt - 25
Suspended Mount to Underbody Bolt - 25
(1) : Always replace after removing.
(2) : Engine code CBFA only.
(3) : Lubricate the stud bolts on the exhaust manifold/turbocharger with hot bolt paste G 052 112 A3.
scientia non olet · About LEMON Manuals