LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (1.8L & 2.0L - Exhaust System & Emission Controls - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Hatchback)) >> 26 Exhaust System, Emission Controls >> General Information >> Clamping Sleeve Locations >> Installed Position For Rear Clamping Sleeve >> Tightening Specifications

Tightening Specifications

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Tightening Torque And Installed Dimension Of Clamping Sleeve
GWWN26-10627Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Clamping sleeve -A- with two individual clamps.

Tightening specification: 25 Nm.

Clamping sleeve -B- with continuous clamp.

Tightening specification 35 Nm.

scientia non olet · About LEMON Manuals