Overview - Muffler, Multi-Link Suspension, Coupe
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Muffler
- Removing and installing, refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Removing and installing, refer to REAR MUFFLER, MULTI-LINK SUSPENSION .
- Bolt
- 25 Nm
- Replace after removing
- Separating Point
- Separating location for repairing
- Identified on exhaust pipe by an impression
- Cut the exhaust pipe at a right angle at the separating point using the Body Saw VAG 1523A or Chain Pipe Cutter VAS 6254, refer to CLAMPING SLEEVE LOCATIONS .
- Center Muffler
- Bolt
- 25 Nm
- Replace after removing
- Exhaust system bracket to body
- Bolt
- 25 Nm
- Replace after removing
- Front tensioning strap to body
- Center muffler bracket to body
- Rear Tunnel Bridge
- To remove and install, refer to UNDERBODY PANELS OVERVIEW .
- Nuts
- Tunnel bridge
- Refer to UNDERBODY PANELS OVERVIEW .
- Clamping Sleeve
- Mounting Strap
- Fuel tank to body
- Bracket
- Replace if damaged
- Bracket
- Replace if damaged