Side Adjusting Buffer and Stop, Removing and Installing: Installing
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
-- Attach the stop -5- to the side panel and install the bolt -6-.
-- Attach the adjusting buffer -4- to the rear lid -1- and install the bolt -2-.
-- Unclip the cap -2- from the adjusting buffer -4-.
| Component |
Tightening Specifications |
| Adjusting buffer bolt -3-. |
8 Nm |
| Stop bolt -6- |
10 Nm |