Front Seat Backrest Release Cable, Adjusting

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Ensure backrest is engaged (zero position), otherwise it can tip forward uncontrolled.

The following prerequisites must be met to adjust:

The upholstery must be removed from the backrest.

NOTE:

The pins (release pins) -2- on both sides must be locked (delivery position, i.e. basic position).

Fig 1: Entry Assistance Release Cables Adjusting, Coupe Only

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tilt the bracket -1- up so there is a distance of -a- = 2 to 4 mm between the backrest frame stop surface -arrow A- and the bracket stop ridge -arrow B-.

Fig 2: Tilting Bracket Up So There Is Distance Between Backrest Frame Stop Surface And Bracket Stop Ridge.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the bracket -1- in this position.

NOTE: The illustration does not show the side cable adjuster.

-- Adjust both of the release cable adjusters -arrows- for the release cables -1- and -2-.

Fig 3: Adjusting Left And Right Release Cables And At Cable Adjusters

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To adjust, turn the upper part -arrow B- and lower part -arrow A- of the release cable adjuster against each other.

-- Adjust the cable so it is free of play and tension.

NOTE:

The illustration only shows one side of the retainer.

When adjusting cables -1-, they must not be tensioned at release pins -2-.

Fig 4: Entry Assistance Release Cables Adjusting, Coupe Only

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- After adjusting release cables, check function of backrest lock.

-- If it does not release or only releases partially, check the release cable routing or repeat the adjustment.