Engine Speed Sensor -G28-: Removing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER .

-- Open the charge air pipe hose clamp -2-.

Fig 1: Air Guide Hose Bolts, Air Guide Pipe Hose Clamps & Electrical Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the electrical connector -arrow-.

-- Remove the noise insulation. Refer to Removal and Installation .

-- Remove the bolts -1 and 4- and remove the charge air pipe downward from the throttle valve control module.

-- Remove the charge air hose by loosening the clamps -1 and 2-

Fig 2: Air Cooler Air Duct

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the engine speed sensor connector -1-.

Fig 3: Engine Speed (RPM) Sensor G28

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the engine speed sensor bolts and sensor.