Engine Speed Sensor -G28-: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation, refer to Overview - Herbie Beetle Decorative Film .

-- Loosen the hose clamp -3- and -5-.

Fig 1: Identifying Sensors And Clamps

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector from the Charge Air Pressure Sensor - G31- -arrow-.

-- Remove the bolts -1- and -4- and then remove the air guide pipe downward.

-- Disconnect the connector -1- on the Engine Speed Sensor -G28-.

Fig 2: Identifying Engine Speed Sensor And Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -arrow-.