CAMSHAFT SEAL VEHICLES WITH "New" SEAL: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the toothed belt for the camshaft and high pressure pump. Refer to Removing .

-- Remove the camshaft sprocket and hub. Refer to Removing .

CAUTION: The thrust pad will fall off the pressure bolt if it is turned backward too far. In this case, it is necessary to press the thrust pad back onto the pressure bolt.

-- Turn back the pressure screw on the seal puller until a slight "resistance" is felt.

NOTE:

The clamping sleeves on the seal puller have set screws. Only one of the set screws -arrow- tightens the clamp. The other one cannot be adjusted.

Fig 1: Identifying Seal Puller And Pressure Screw

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the seal puller as shown and turn the set screw -A-.

Fig 2: Identifying Seal Puller And Set Screw

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn the pressure screw -B- until the seal is pulled out.