Vacuum Pump: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter (engine cover). Refer to AIR FILTER HOUSING .

-- Remove the battery and the battery tray. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] Removal and Installation .

-- Remove the intake air scoop from the lock carrier -arrows-.

Fig 1: Identifying Air Guide On Lock Carrier

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the intake hose -4-. Remove the air hoses -1- (if equipped) and -2- (press the locking ring) and the spring clamp -3-.

Fig 2: Identifying Air Hoses And Are Fitted Securely

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip wiring harness from bracket -2-.

Fig 3: Locating 3 Bolts And Vacuum Pump

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -3- from the coolant pipe.

-- Disconnect vacuum hose -1-.

-- Remove the 3 bolts -arrows- and the vacuum pump.

NOTE: The 4 cover bolts must not be loosened under any circumstances!

-- Remove the old seal.