Vacuum Pump: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the new seal -2- on the vacuum pump.

Fig 1: Identifying New Gasket On Placed On Vacuum Pump

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place vacuum pump coupling plate -3- so that it engages into symmetrical groove of double chain sprocket (drive wheel) -1- -arrows- when installing vacuum pump.

-- Tighten the bolts.

The rest of the installation follows the reverse of the removal procedures.

-- Install the battery tray. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] Removal and Installation .

-- Install the battery. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] Removal and Installation .