Fuel Injector Seals: Procedure

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the fuel injector in question, refer to OVERVIEW - FUEL INJECTORS .

-- Install the Puller - Shaft Seal T40195 into the seal -1-.

Fig 1: Identifying Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the Slide Hammer T10133/3 to the seal puller with the adapter T10133/2 as shown and remove it by tapping it upward.

-- Install the new fuel injector seal with the Torque Adapter 3390 and short extension -1- all the way and from above.

Fig 2: Identifying Torque Adapter And Short Extension

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.