Windshield Wiper Motor -V-: Installation

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the Windshield Wiper Motor -V- with the Windshield Wiper Motor Control Module -J400- in the wiper frame and tighten the bolts -arrows-.

Fig 1: Identifying Wiper Frame Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the motor crank -4- onto the Windshield Wiper Motor -V- shaft -2- so that the three points -1-, -2- and -3- are in a line.

Fig 2: Identifying Motor Crank, Wiper Motor Shaft And Alignment Of Points

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the motor crank and the Windshield Wiper Motor -V- shaft with the nut -2-.

-- Push the ball head -arrow- on the linkage -1- onto the motor crank.

Fig 3: Installing Wiper Motor Linkage

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.