Electronic Anti-Theft Protection

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

The Radio -R- is equipped with anti-theft coding, which operates in conjunction with the instrument cluster.

After disconnecting the power supply to the Radio -R-, it is ready for use and the anti-theft code does not need to be entered again. The requirement is that the anti-theft coding must be activated for the first time and that the Radio -R- is reconnected in the same vehicle.

Use the Vehicle Diagnostic Tester to get the anti-theft code. The radio card and the label on the Radio -R- that were used in the past are no longer used.

The Vehicle Diagnostic Tester must be connected "online" to determine the anti-theft code. The user must have the proper authorization to access the anti-theft code.

Reactivating a locked Radio -R- is only possible by entering the correct anti-theft code for anti-theft coding.

Using Vehicle Diagnostic Tester to get the anti-theft code:

-- Vehicle Diagnostic Tester Connect.

-- Select Guided Fault Finding .

-- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:

Body
Electrical Equipment
01-OBD-capable system
Sound System
Sound System functions
Radio code inquiry

Authorization will be requested from the system: Then the operating data, the VIN and the Radio -R- serial number will be automatically read out.

NOTE:

The Vehicle Diagnostic Tester may not be able read the Radio -R- device number when a new Radio -R- is installed. In this case enter the unit number manually. The device number can be found on a sticker on the Radio -R- and is also stamped on the side of the device.

The Vehicle Diagnostic Tester will display the anti-theft code.

The anti-theft code must be entered manually into the Radio -R-.

Electronic Anti-Theft Protection, Deactivating:

-- Switch on the Radio -R-.

"SAFE" appears in the display for approximately 10 seconds, after that "1000" appears.

-- Push the station buttons repeatedly until the correct code number sequence is displayed.

"OK" appears in the display after the four-digit code number has been entered.

-- "OK" appears in the display when the correct anti-theft code has been entered.

The Radio -R- is enabled and ready to be used.

If an incorrect anti-theft code is entered, the code can be entered a second time. If anti-theft code is entered incorrectly twice, then the Radio -R- will lock up for one hour. Leave the Radio -R- and ignition on. The procedure can be repeated after one hour.

NOTE: The anti-theft code can be attempted two times. After that, the Radio -R- locks up for one hour.