Overview - Oil Pan/Oil Pump
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and installing, refer to Oil Level Thermal Sensor -G266- .
- Seal
- Replace after removing
- Bolt
- Replace after removing
- Tightening sequence, refer to Fig 2
- Seal
- For oil pan lower sections only
- O-Ring
- Replace after removing
- Coat with engine oil
- Bolt
- 4 Nm + 45°
- Replace after removing
- Intake Line
- Clean the screen if it is dirty.
- O-Ring
- Replace after removing
- Coat with engine oil
- Oil Pump
- Removing and installing, refer to OIL PUMP .
- Centering Sleeve
- O-Ring
- Replace after removing
- Coat with engine oil
- Bolt
- Tightening specification, refer to -item 1-.
- Oil Pressure Regulation Valve -N428-
- Removing and installing, refer to Oil Pressure Regulation Valve -N428- .
- Chain Tensioner
- Oil Pump Drive Chain
- Mark direction of rotation before removing
- Bolt
- 9 Nm
- Cylinder Block
- Oil Pan Upper Section
- Removing and installing, refer to OIL PAN UPPER SECTION .
- Bolt
- Replace after removing
- Tightening sequence, refer to Fig 3
- O-Ring
- Coat with engine oil
- Replace after removing
- Bolt
- 4 Nm + 45°
- Replace after removing
- Oil Return Pipe
- Bolt
- 8 Nm + 90°
- Replace after removing
- Oil Baffle
- Replace after removing
- Bolt
- 4 Nm + 45°
- Replace after removing
- Oil Pan Lower Section
- There are different versions.
- Removing and installing, refer to OIL PAN LOWER SECTION .
- Seal
- Replace after removing
- Coat the O-ring with engine oil
- Seal for sheet metal oil pan lower sections
- Oil Drain Plug
- 30 Nm
- Oil drain plug for sheet metal oil pan lower sections
NOTE:
Replace the bolts were tightened with an additional turn.
-- Tighten the bolts -1- through -20- in two stages and in the sequence as shown:
| Stage | Tightening Sequence/Tightening Specification |
|---|---|
| 1. Bolts -1- through -20- | Tighten to 8 Nm |
| 2. Bolts -1- through -20- | 45° (1/8) additional turn |
NOTE:
Replace the bolts were tightened with an additional turn.
-- Tighten the bolts -1- through -14- in five stages and in the sequence as shown:
| Stage | Tightening Sequence/Tightening Specification |
|---|---|
| 1. Bolts -1- through -14- | Tighten to 8 Nm |
| 2. Bolts -1- and -2- | 180° (1/2) additional turn |
| 3. Bolts -3- through -9- | 45° (1/8) additional turn |
| 4. Bolt -10- | 180° (1/2) additional turn |
| 5. Bolts -11- through -14- | 90° (1/4) additional turn |