OVERVIEW - OIL PRESSURE SWITCHES -F1- AND -F378-, Oil Pressure Regulation Valve -N428-
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 4 Nm + 90°
- Replace after removing
- Oil Pressure Regulation Valve -N428-
- Removing and installing, refer to Oil Pressure Regulation Valve -N428- .
- O-Ring
- Replace after removing
- Coat with engine oil
- O-Rings
- Not installed
- Bolt
- Not installed
- Piston Cooling Nozzle Control Valve -N522-
- Not installed
- Seal
- Replace the seal with the oil pressure switch.
- The seal cannot be replaced separately.
- Oil Pressure Switch -F1-
- 20 Nm
- Blue or gray insulation
- Checking Vehicle Diagnosis Tester
- Removing and installing, refer to Oil Pressure Switch -F1- .
- Reduced Oil Pressure Switch -F378-
- 20 Nm
- Brown insulation
- Checking Vehicle Diagnosis Tester
- Removing and installing, refer to Reduced Oil Pressure Switch -F378- .
- Seal
- Replace the seal with the oil pressure switch.
- The seal cannot be replaced separately.
- Seal
- Not installed
- Oil Pressure Switch, Level 3 -F447-
- Not installed