Oil Pan: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Be sure to check the expiration date of the sealant.

The oil pan must be installed within five minutes after application of silicone sealant.

-- Cut the tube nozzle at the front marking (nozzle diameter: approximately 3 mm).

Fig 1: Applying Sealant To Clean Sealing Surface

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Silicone - Apply sealant on the cleaned sealing surface on the oil pan as shown. The sealing compound bead must be:

2 to 3 mm thick
and run on inside of bolt holes -arrows-

NOTE: Sealant bead must not be thicker than specified. Otherwise, excess sealant could get into oil pan and clog strainer in intake line of oil pump.

-- Apply silicone sealing compound bead as shown to clean sealing surface of oil pan. (The illustration shows the location of the sealant bead on the crankshaft housing.)

Fig 2: Identifying Clean Sealing Surfaces Sealant Application Areas

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the oil pan immediately and tighten the oil pan/transmission bolts and all the oil pan bolts loosely.

-- Make sure the oil pan lies flush on the intermediate plate/transmission flange.