Transmission Fluid, Checking

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench (5-50 Nm) V.A.G 1331
Triple Square Socket Driver 3357

For the correct transmission fluid specification.

-- Remove the noise insulation. Refer to Removal And Installation .

-- Remove the filler plug for checking the transmission fluid level -arrow-.

Fig 1: Identifying Oil Filler Locking Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The level is correct when the transmission fluid comes up to the bottom edge of the filler hole.

-- Install the plug -arrow- with a new seal.

-- Tighten the plug -arrow- to specification. Refer to Fig 2.

Note the following when filling for the first time:

-- Remove the filler plug -arrow-.

-- Add transmission fluid until it reaches the lower edge of the filler hole.

-- Install the filler plug -arrow- with a new seal.

-- Tighten the filler plug -arrow- to specification. Refer to Fig 2.

-- Install the noise insulation. Refer to Removal And Installation .

Fig 2: Different Versions Of Oil Drain Plugs

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

I - Fluid filler or drain plug with a multipoint socket head, 45 Nm

II - Fluid filler or drain plug with a hex socket head, 30 Nm