Refrigerant Circuit: Condenser: Installing
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Installation is carried out in the reverse order while observing the following:
- Coat the new refrigerant line sealing rings with refrigerant oil before installing.
NOTE:
If the condenser was replaced, only open the caps on the condenser-block connection prior to installation.
Only remove the caps from the Engine Bung Set VAS 6122 from the refrigerant lines just prior to installation.
Installation is carried out in the reverse order while observing the following:
- Coat the new refrigerant line sealing rings with refrigerant oil before installing.
NOTE:
If the condenser was replaced, only open the caps on the condenser-block connection prior to installation.
Only remove the caps from the Engine Bung Set VAS 6122 from the refrigerant lines just prior to installation.