Fresh Air Blower -V2-: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the plastic screws -2- and the front passenger side footwell trim panel -1-.

-- Remove the glove compartment. Refer to REMOVAL AND INSTALLATION .

Fig 1: Identifying Partition

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the footwell vent on the front passenger side. Refer to FRONT PASSENGER SIDE FOOTWELL VENT .

-- Disconnect the connector -2- from the Fresh Air Blower -V2- -1-.

-- Release the locking mechanism -arrow A- and turn the Fresh Air Blower -V2- with the Fresh Air Blower Control Module -J126- -1- in the direction of -arrow B-. Release the locking mechanisms -3- by turning them.

-- Remove the Fresh Air Blower -V2- and the Fresh Air Blower Control Module -J126- -1- from the heater and A/C unit -4-.

Fig 2: Identifying Fresh Air Blower Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.