LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Air Conditioning (Convertible)) >> 87 Air Conditioning >> Description And Operation >> Belt Pulley Overview (Denso)

Belt Pulley Overview (Denso)

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Different versions of the ribbed belt pulley may be installed, depending on A/C compressor construction type and engine version.

Ribbed belt pulley, removing and installing. Refer to BELT PULLEY, DENSO '.

Fig 1: Identifying Belt Pulley Components Overview (Denso)
GWWM87-10021Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Cap
  2. Cover with Locking Ring
    • Remove carefully using a small screwdriver or needle-nose pliers (pay special attention to ribbed belt pulley when doing this)
  3. Drive Plate
    • Remove with the Wrench - Pin Type 3212
  4. Circlip
    • Always replace
    • Install on correct side (flat side toward A/C compressor)
  5. Spacer
  6. Ribbed Belt Pulley
    • The ribbed belt pulley is made of plastic and is sensitive to impact. Be especially careful when handling it.
    • There are different versions.
  7. A/C Compressor
    • Depending on engine and market version, different versions can be installed.
    • Clean A/C compressor flange before sliding on ribbed belt pulley.
  8. Rubber Element
    • Quantity: 6
    • Decouples the ribbed belt pulley from the A/C compressor input shaft and dampens vibration and noise
    • To install, lightly coat rubber elements, for example, with tire mounting paste or a soap solution (as a lubricant)
scientia non olet · About LEMON Manuals