Exhaust Pressure Sensor 1 -G450-: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover, refer to ENGINE COVER .

-- Open the heat shield boot -1-.

Fig 1: Identifying Exhaust Pressure Sensor, Bolts, Clamps And Connectors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -8-.

-- Remove the bolt -2- and push the Differential Pressure Sensor -G505- -3- slightly to the side.

-- Disconnect the connector -6-.

-- Remove the bolt -4-.

-- Before removing, spray the Exhaust Pressure Sensor 1 -G450- -5- hoses with a thinner.

-- Loosen the hose clamps -7-.

CAUTION:

There is a risk of damaging the differential pressure sensor by breaking the connection.

Remove the hose carefully and evenly from the connection.