Differential Pressure Sensor -G505-: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover, refer to ENGINE COVER .

-- Open the heat shield boot -1-.

Fig 1: Identifying Clamp, Bolt And Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -4-.

-- Remove the bolt -3-, and remove the Differential Pressure Sensor -G505- from the bracket.

-- Spray the hose on the Differential Pressure Sensor -G505- with thinner before removing.

-- Loosen the clamp -2- and remove the hose.

CAUTION:

There is a risk of damaging the differential pressure sensor by breaking the connection.

Remove the hose carefully and evenly from the connection.