LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (2.0L - Fuel Mixture Preparation & Fuel Injection - Engine Code(S): CJAA & CVCA (Hatchback)) >> 23 Fuel Mixture Preparation, Fuel Injection >> Removal And Installation >> Heated Oxygen Sensor -G39- >> Installing

Heated Oxygen Sensor -G39-: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

New oxygen sensors are coated with assembly paste; the paste must not get into slots of oxygen sensor body.

For a used oxygen sensor, only coat threads with hot bolt paste. This paste must not come into contact with sensor slots. Hot bolt paste.

Always install the oxygen sensor wire in the same location so it does not come into contact with the exhaust pipe.

scientia non olet · About LEMON Manuals