Fuel Pressure Regulator Valve -N276-: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Check the Fuel Pressure Regulator Valve -- sealing surface and threads for damage.

Check the sealing surface on the rail element bore.

The threads on the Fuel Pressure Regulator Valve -- must be free of oil and grease.

-- First tighten the union nut on the Fuel Pressure Regulation Valve -- by hand.

-- Align the Fuel Pressure Regulator Valve -N276- so the connecting line is not taut after connecting the electrical connector.

-- Counterhold at the housing hex bolt and tighten the union nut:

Tightening specification -item 6-.

-- After installing, let the engine run at a moderate speed for a few minutes and then stop it.

-- Check the fuel system for leaks. Refer to FUEL SYSTEM, PERFORMING LEAK TEST .

-- The DTC memory for the Engine Control Module -- again Vehicle Diagnostic Tester "Guided Functions".

-- Install the engine cover. Refer to ENGINE COVER .