Brake Caliper Piston, Rear Brakes ZOH BIR 38: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the brake caliper. Refer to BRAKE CALIPER, REAR BRAKES BOSCH ZOH BIR 38 .

WARNING: Adjust the brake piston is permitted only with the Brake Caliper Tool T10165.

-- Remove piston from brake caliper by turning knurled wheel toward left.

Install the Brake Caliper Tool T10165 so that the collar touches the piston.

Fig 1: Identifying Installation And Operation Of Plate T10165

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

For pistons that are difficult to move, an open-end wrench (size 13 mm) can be applied at the appropriate wrench surface -arrow A-.

-- Remove the sealing ring using the Trim Removal Wedge 3409.

Fig 2: Identifying Wedge 3409 To Remove Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.