Brake Caliper Piston, FN 3: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the brake caliper. Refer to BRAKE CALIPER, BRAKE CALIPER FN3 .

-- Force piston from brake caliper using compressed air -arrow-.

Fig 1: Identifying Brake Caliper Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Place a wooden board into the recess of the caliper housing so it is not damaged.

-- Remove the cap from the brake caliper using the Trim Removal Wedge 3409.

Fig 2: Identifying Protective Cap Pried Off From Brake Caliper With Trim Removal Wedge 3409

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the sealing ring using the Trim Removal Wedge 3409.

Fig 3: Identifying Removal Of Brake Caliper Seal With Wedge 3409

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

When removing, make sure that surface of cylinder is not damaged.