General Information
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury. Follow all warning messages and safety precautions, refer to WARNINGS AND SAFETY PRECAUTIONS .
It is not necessary to disconnect or remove the Battery -A- when using the Battery Tester with Printer VAS 5097A.
The following Batteries -A- can be tested using the Battery Tester with Printer VAS 5097A:
- 80 to 499 A cold crank amps according to German Industry Standardization DIN (Deutsche Industrie Norm), refer to -item 1-.
- 95 to 574 A cold cranking output according to IEC (International Engineering Consortium)
- 136 to 855 A cold cranking output according to EN/ SAE (Europαische Norm/ Standard of Automotive Engineers)
- Batteries -A- with cold crank amps greater than 499 A according to DIN can be tested with the setting for 499 A according to DIN.
The Batteries -A- are tested by being loaded with current that corresponds to the starter current of a vehicle. Under this load, the Battery -A- is evaluated and the measured results are output through the printer.
NOTE:
Read the Battery Tester with Printer VAS 5097A Operating Instructions and Battery Tester with Printer VAS 5097A Quick Reference Guide label on the Battery Tester with Printer VAS 5097A and the cold crank amps table, refer to COLD CRANK AMPS TABLE .
- Battery Tester with Printer VAS 5097A device description, refer to Battery Tester with Printer VAS 5097A DEVICE DESCRIPTION .
- Battery load test, refer to BATTERY LOAD TEST .
- Cold crank amps table, refer to COLD CRANK AMPS TABLE .
- Battery load test results, refer to BATTERY LOAD TEST RESULTS .
- Printed test results explanations, refer to PRINTED TEST RESULTS EXPLANATIONS .
- Test result evaluation, refer to TEST RESULT EVALUATION .