Battery Tester Charger Kit GRX 3000 VAS TROUBLESHOOTING
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Sometimes the display shows the malfunction or the messages based on the condition.
The following is a list of the most frequent displayed messages together with suggested solutions.
NOTE:
For any messages not listed, refer to the Battery Tester Charger Kit GRX 3000 VAS Operating Instructions.
| Display Message | Measure |
|---|---|
| Check the connection | -- Make sure the Battery Tester Charger Kit GRX 3000 VAS charging clamps are attached securely to the battery terminals. -- Make sure the battery pole is tightened to the tightening specification and is not corroded. |
| Terminals connected? | Battery Tester Charger Kit GRX 3000 VAS safety function. -- Connect the charging clamps to the Battery -A- before starting the charging process. |
| System noises | -- Switch off all electrical consumers. -- Wait until all electrical equipment, which are monitored by the Vehicle Electrical System Control Module -J519-, are switched off. -- Remove the key. -- Disconnect any doubtful or standard production electrical equipment from the vehicle electrical system. |
-- Wait a few minutes and repeat the charging process, refer to BATTERY, CHARGING WITH Battery Tester Charger Kit GRX 3000 VAS