ADAPTING Battery Monitoring Control Module -J367-: Notes

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

The procedure for "replacing the Battery Monitoring Control Module" includes the following steps:

If a new Battery Monitoring Control Module -J367- is installed in the vehicle, then the Battery Monitoring Control Module -J367- must be coded.
Then the Battery Monitoring Control Module -J367- must be adapted.

The procedure to "replace the Battery Monitoring Control Module" can only be performed Vehicle Diagnostic Tester in the "guided fault finding" function.