ATF Cooler: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE: Replace the O-ring after disassembly.

-- Install the plate spring. See -item 6-:

It must contact the washer -item 5-.
The convex side of the plate spring faces up.

-- Insert the tab -arrow B- into the opening in the transmission housing when installing the ATF cooler -1-.

-- Install the coolant hoses to the ATF cooler according the markings made during the removal.

-- Check the coolant level and fill if necessary. Refer to COOLING SYSTEM, CHECKING FOR LEAKS .

-- Install the battery tray and the battery. Refer to [For engine(s) CVCA,CPRA,CBTA,CPKA,CPLA,CJAA,CBUA,CPPA,CCTA,CBFA] Removal and Installation .

-- Check the ATF level. Refer to Checking .

-- Install the engine cover by gently pushing the engine cover down, and the air filter. Refer to AIR FILTER HOUSING .