LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Maintenance Procedures (Hatchback)) >> 03 Maintenance, Diagnosis >> Maintenance Procedures >> Spark Plugs, Replacing >> 1.8L (125 Kw) And 2.0L (155 Kw) TSI Engine >> Installing

1.8L (125 Kw) And 2.0L (155 Kw) TSI Engine: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Use the Spark Plug Removal Tool 3122 B to tighten the new ignition coils to specification.

-- Align all ignition coils with the power output stage one after the other and insert them loosely into the spark plug shaft.

-- Press the ignition coil with power output stage evenly by hand onto spark plugs (do not use a hammer).

-- Tighten the ignition coil with power output stage bolts to the tightening specification.

-- Connect the connector at the same time.

-- Install the "upper" engine cover. Refer to UPPER ENGINE COVER, REMOVING AND INSTALLING .

Tightening Specification  Nm
Spark plugs in cylinder head 30
Ignition coil with power output stage bolts. 10
scientia non olet · About LEMON Manuals