SERVICE INTERVAL DISPLAY, RESETTING WITH Vehicle Diagnostic Tester

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the Vehicle Diagnostic Tester. Refer to Vehicle Diagnostic Tester .

-- Switch on the ignition.

-- Select >>Guided Functions<<.

If the displays indicated in the procedure are not shown on the display: Refer to => Operating Instructions for Vehicle Diagnostic Tester.

-- Select the following one after the other:

Brand
Type
Model year
Engine code

-- Confirm the VIN.

-- Select the following one after the other:

Vehicles through MY 2013

"Instrument Cluster"
"Service Interval Display, Resetting"

Vehicles from MY 2014

"Instrument Cluster"
Select the service that is to be reset.

All vehicles

-- Adapting according to "Guided Functions".

End Adaptation

-- Select Go to and then press End .

-- Turn off the ignition and disconnect the diagnostic connector.

-- Switch on the ignition.

After switching on the ignition, service event is no longer indicated in the odometer display in the instrument panel insert.