Test Diagram For Low Beam

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Check the following:

-- With the low beam switched on check whether the horizontal light-dark border of the setting line -1- contacts the test surface.

Fig 1: Identifying Headlamp Adjustment Setting Line, Break-Away Point And Center Point/Mark

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- whether the break-away point -2- between the left horizontal part and the rising part on the right of the light-dark border runs vertically through the central point -3-. The bright core of the light beam must be on the right of the vertical line.

NOTE:

To make it easier to find break-away point -2- cover and uncover left half of headlamp (as viewed when looking forward) a few times. Then check low beam again.

After correct adjustment of lowbeams the center point of the main beam must lie on the center mark -3-.