Measure Preparations
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Wheel Alignment Computer VAG 1813F or VW/Audi approved alignment equipment
- Brake Pedal Actuator VAG 1869/2
- Insert Tool 18 T10179
- Shock Absorber Set T10001
NOTE:
The lateral run-out of the wheel must be compensated for. Otherwise, measurement will result in false readings.
A correct toe-in adjustment will not be possible without performing lateral run-out compensation!
Follow the operating instructions provided by the manufacturer of the alignment equipment.
-- Carry out wheel run-out compensation.
-- Insert Brake Pedal Actuator VAG 1869/2.
-- Actuate the brake pedal using brake pedal actuator.
CAUTION:
Check the axle beam trailing arm. Refer to AXLE BEAM TRAILING ARM (TORSION BEAM), CHECKING WITH VAS 241001 or AXLE BEAM TRAILING ARM (TORSION BEAM), CHECKING WITH VW 801 .