Installing/Conditions For Using Run-Flat Tires

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Using run-flat tires on Volkswagen vehicles is permitted only if the run-flat tire is supplied with the vehicle either as standard equipment or as an option.

Because pressure loss in a run-flat tire is not always visible, these tires should only be used on vehicles equipped with a tire pressure monitoring system. This system warns the driver when the tire pressure falls below a certain value.

The following are permitted:

Systems that measure directly. Refer to General Information .

Systems that measure indirectly. Refer to General Information .

Only mount run-flat tires on disc wheels with an extended double hump (extended hump - EH2). Refer to WHEEL CONSTRUCTION .

Read and follow the special mounting instructions. Refer to General Information .

Do not install both run-flat tires and standard tires, even if the two tires on each axle will be the same.

A standard tire can only be installed in exception cases for a short time or a limited driving distance. The specific characteristics designed for driving with a flat tire will not be available. The driver must be informed of this.

NOTE:

Always pay attention to the recommended tire manufacturer. Refer to General Information .