Special Tools

Special Tools And Workshop Equipment Required 

• Holding Plate VW 309
• Torque Wrench (5-50 Nm) VAG 1331
• Thrust Plate VW 401
• Thrust Plate VW 402
• Thrust Disc VW 412
• Thrust Pad 16.5/28 mm Dia. VW 431
• Arbor 50 mm Dia. VW 432
• Thrust Tube VW 454
• Locking Pin 30-505
• Thrust Piece 40-105
• Press Tube 2040
• Punch VW 408 A
• Tube 60 mm Dia. VW 415 A
• Holding Fixture VW 313
• Thrust Pad VW 512
• Tube 42 mm Dia. VW 516
• Sleeve VW 519
• Slide Hammer-Complete Set VW 771
• Support Channels VW 457
• Thrust Tube VW 455
• Thrust Pad VW 510
• Thrust Pad 30-11
• Tube 3296
• Attachment to VAG 1582 VAG 1582/4
• Pulling Hook T20143
  Fig 1: Extractor Hook T20143

  Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
• Thrust Piece T40008
  Fig 2: Identifying Thrust Piece T40008

  Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
• Inductive Heat Unit VAS 6414
  Fig 3: Identifying Inductive Heater VAS 6414

  Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
• -1- Kukko Extractor 30-37 mm 21/5
• -1- Kukko Extractor 46-58 mm 21/7
• -1- Kukko Extractor 56-70 mm 21/8
• -2- Kukko Puller 65-160 mm 18/1
• -2- Kukko Puller 80-210 mm 18/2
• -3- Kukko Separating Tool 12-75 mm 17/1
• -3- Kukko Separating Tool 22-115 mm 17/2
• -4- Kukko Support 22/2
  Fig 4: Identifying Kukko Tools

  Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Fig 5: Identifying Special Tools - Output Shaft, Adjusting

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Special tools and workshop equipment required 

• Transmission Support VW 353
• Dial Gauge Holder VW 387
• Punch VW 407
• Thrust Pad Con. 8/65 VW 433
• Installation Arbor VW 792
• Holding Fixture VW 801

Fig 6: Identifying Special Tools -- Output Shaft For 1st To 4th Gear, Disassembling And Assembling

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Special tools and workshop equipment required 

• Sleeve 40-20
• Sleeve 40-21
• Thrust Plate 2050
• Spacers VW 540/1B
• Tapered Roller Bearing Puller VAG 1582
• Grip VAG 1582/7