Right Flange Shaft And Seal: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Oil Seal Sealing Lips

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lightly coat the outer circumference of the new seal with oil.

-- Fill the area between the sealing and dust lips -arrow- halfway with sealing grease G 052 128 A1.

-- Drive in the new seal until seated and without tilting it, using the thrust piece 3305.

Fig 2: Driving New Seal In As Far As Stop

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the flange shaft -A- against the pressure spring on the transmission housing and tighten the bolt.

Fig 3: Identifying Left/Right Drive Axles Onto Flange Shafts, Installation

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the right drive axle to the transmission flange shaft -A-. Refer to REMOVAL AND INSTALLATION .

-- Install the heat shield and bolts -arrows-, if equipped. Refer to SPECIAL TOOLS .

Fig 4: Drive Axle Heat Shield Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the transmission fluid level and fill if necessary. Refer to TRANSMISSION FLUID, CHECKING .

-- Install the noise insulation. Refer to REMOVAL AND INSTALLATION .