Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts in three steps and in the sequence shown:

Stage	Bolts	Tightening Specification
1.	-1 ••• 10-	Install all the way in by hand.
2.	-1 ••• 6-	Diagonally in steps at least to 15 Nm
3.	-7 ••• 10-	15 Nm

Fig 2: Engine Mount Bracket To Cylinder Block Bolt Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tighten the bolts in the sequence -1-, -2- and -3 -.

NOTE: Replace the bolts for the engine support.

-- Tighten the bolts in three steps and in the sequence shown:

Stage	Bolts	Tightening Specification/Rotation Angle
1.	-1- through -3-	7 Nm
2.	-1- through -3-	40 Nm
3.	-1- through -3-	Tighten 180° additional turn